1 850,00 zł ≈ 420,28 €
Cloning is the complete transfer of the contents of the original ECU Bosch MD1CS069 to a new, working unit of the same type. To complete the service, send us both ECUs – the old (original) and the new (target) one. We copy the complete software along with the data (flash + EEPROM/calibration) from the old unit to the new one and return an ECU ready to install. The cloned unit works 1:1 just like the original – maintaining compatibility with the immobilizer, the VIN number and vehicle adaptations, with no visit to an authorized dealer. This is the solution in case of physical damage, water damage or a locked original ECU.
We transfer the complete contents of the ECU – software and data – to the target MD1CS069 unit, with no hasty shortcuts.
The cloned ECU retains the VIN number, immobilizer data and adaptations, so the vehicle starts without additional coding at an authorized dealer.
We send back a working, cloned ECU – just connect it in the vehicle.
The service is intended for workshops, automotive electronics specialists and drivers replacing a damaged Bosch MD1CS069 ECU with a working unit – including vehicles such as the Iveco Daily and other models using this unit.
Have questions about cloning a Bosch MD1CS069 ECU? Check the answers to the most frequently asked questions.
Send us both Bosch MD1CS069 ECUs – the old one (original, serving as the data source) and the new one (target, to which we transfer the contents). Pack both carefully, preferably in anti-static film with protective padding.
We will provide the shipping address after you place your order. If you have any questions, write to [email protected], including your order number and the vehicle and ECU details.
Yes. Cloning transfers the complete contents, including immobilizer data, VIN and adaptations, so the target ECU works just like the original – no coding at a dealership required.
The cloning itself is usually completed within 24–48 business hours of receiving the ECU. Add to this the courier shipping time in both directions.
Yes. Cloning requires both units of the same type (MD1CS069): the old one as the data source and the new one as the target unit. If you don't have a second ECU, contact us before purchasing – we'll advise you on how to obtain a suitable unit.
Fill in our simple contact form. We will answer your question as soon as possible.
Bosch MD1CS069 cloning